1Pub. 988-0147-582Installation Instructions forSkimmer TransducersSingle- or Dual-FrequencyThis instruction booklet will help you install your Skimme

10the hull as shown in the preceding and following figures. Tighten thebracket's mounting screws, sealing them with the sealant/adhesivecompound.

11 Manual locking collar connector Push-on self-sealing connectorrequires a 1" hole. require

12ing motor shaft. Make sure there is enough slack in the cable for themotor to turn freely. Route the cable to the sonar unit and the trans-ducer is

13If the arch slopes up – but not back down – then the front of the trans-ducer is too high and needs to be lowered. If only the back half of thearch

14sonar signal must pass through solid fiberglass. Any air bubbles in thefiberglass or the epoxy will reduce or eliminate the sonar signals.Testing De

152. Next, take the transducer out of the water and place it in the water inthe sump of the boat, face down. (The transducer face is shown in thefigur

16Epoxy transducer to hull.WARNING:Use only the epoxy available from LEI. It has been for-mulated to work with these installation procedures.Other ep

17oxy is wet. Leave the weight in place for a minimum of three hours.Allow the epoxy to cure for 24 hours before moving the boat.5. After the epoxy ha

18Notes

19LEI EXTRASFULL ONE-YEAR WARRANTY"We," "our," or "us" refers to LEI EXTRAS, INC., the manufacturer of this product. &qu

2Dual-frequency transom installationsTools: two adjustable wrenches, drill, #20 (0.161") drill bit, flat-headscrewdriver. Supplies: four, 1"

20How to Obtain Service……in the USA:Contact the Factory Customer Service Department. Call toll-free:For Lowrance: 800-324-1356. For Eagle: 800-324-135

3interfere with the trailer or hauling of the boat. Also, don't mount itcloser than approximately one foot from the engine's lower unit. Thi

4slightly higher or lower. (The slots in the mounting brackets allow youto loosen the screws and slide the transducer up or down.) If you fre-quently

5TRANSOM TRANSDUCER ASSEMBLY AND MOUNTINGThe best way to install these transducers is to loosely assemble all ofthe parts first, place the transducer&

6Insert and align ratchets.Add ratchets to bracket and transducer.2. Aligning the transducer on the transom.A. One-piece bracket: Slide the transducer

7parallel with the ground. If you can, then go to step 3A. If it doesn't,repeat step 2A, but use a different alignment letter until you canplace

8Assemble transducer and bracket.3. Assembling the transducer.A. One-piece bracket: Once you determine the correct position forthe ratchets, assemble

9screws). For the two-piece bracket, use the #20 bit (for the #12screws). Position transducer mount on