Eagle 320 Manual do Utilizador descarregar pdf (Página 18)

Page 16 of 32P/N 595176-01 Rev. C 1/11

2. Hold the EAGLE IMAGER 320 by the handle and adjust the tilt of the handle

to one of three positions for viewing. See POSITIONING THE HANDLE

section of this instruction.

CAUTION

DO NOT POINT THE EAGLE IMAGER 320 THERMAL CAMERA DIRECTLY

AT THE SUN. DO NOT POINT THE CAMERA AT HEAT SOURCES IN

EXCESS OF 2700° F / 1500° C FOR EXTENDED PERIODS OF TIME.

DOING SO MAY RESULT IN AN AFTER IMAGE ON THE DISPLAY THAT

COULD CAUSE TEMPORARY REDUCTION IN PERFORMANCE OF THE

CAMERA. IF THIS OCCURS, DO NOT USE UNTIL PERFORMANCE HAS

RETURNED TO NORMAL.

FIGURE 12

LEFT

BUTTON

RIGHT

BUTTON

USING THE EAGLE IMAGER 320 THERMAL CAMERA

1. Press the RIGHT button below the camera display. Green LED’s in the

buttons will light as the display is illuminated. An initialization screen will

appear for approximately three (3) seconds (see FIGURE 12) after which the

thermal image will appear in the display screen. As the system completes

the initialization, the icons will appear around the display screen.

When the camera is powered up, it will begin operating in whatever display

mode was active when the camera was properly shut down. The optional

transmitter will also return to its last active state.

NOTE

WHEN THE EAGLE IMAGER 320 THERMAL CAMERA IS POWERED UP,

THE SCREEN WILL DISPLAY THE TEMPERATURE INDICATORS ALL THE

TIME.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Sem comentários

Eagle 320 Manual do Utilizador Página 18