Eagle 320 Especificações descarregar pdf (Página 20)

Assemble transducer and bracket.

4. Drilling mounting holes. Hold the transducer and bracket assembly

against the transom. The transducer should be roughly parallel to the

ground. The transducer's centerline should be in line with the bottom of

the hull. Don't let the bracket extend below the hull!

Mark the center of each slot for the mounting screw pilot holes. You

will drill one hole in the center of each slot.

Drill the holes using the #29 bit (for the #10 screws).

Position transducer mount on transom and mark mounting holes.

Side view shown at left and seen from above at right.

Nut

Metal

washer

Metal washer

Bolt

Rubber

washers

Transom

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 103 104

Sem comentários

Eagle 320 Especificações Página 20