Eagle 105 Manual de Instruções descarregar pdf (Página 13)

Weather Eagle® 105-110 Instruction Manual Page-13-

10 Muted audio out

11 12VDC out

12 5VDC out

13 Remote Play switch (active high +5vdc)

14 open connection

15 Ground

Use the Pin 12, +5VDC power supply to activate the remote switches (manual, scan,

reset and live) Pins 1, 2, 3 and 4. NOTE: If the WE105 is also connected to a repeater

controller or other external logic, diodes may need to be added to inputs 3 and 4 (live

and reset) to avoid the external logic from holding the Weather Eagle® logic low, and

preventing the Alert Eagle® from automatically activating the WE105. An interface

schematic is posted on the www.thuneagle.com/login website.

16) Upload New Firmware

The WEATHER EAGLE® is operated by a powerful computer (microcontroller) with

electronically flash program memory. You need the ICD-40S programmer to update the

firmware. Install the ICD-40S on your workstation. Open the WEATHER EAGLE® case

(two screws on the bottom of the case). With the WEATHER EAGLE® powered on, plug

the ICD-40S into the RJ-45 on the WEATHER EAGLE® and plug the serial connector

into your workstation. Click download to target. Navigate to the file to upload to the

WEATHER EAGLE®. **MAKE SURE YOU ONLY UPLOAD WEATHER EAGLE®

SOFTWARE TO THE WEATHER EAGLE®!! *** A progress bar should appear and the

download and file verification should take less than 30 seconds. Click the Run Program

button. The WEATHER EAGLE® should come to life. Press the buttons and test the

functions on the WEATHER EAGLE® to make sure the download was successful.

Unplug the ICD-40S from the WEATHER EAGLE® and from your workstation.

Reassemble the WEATHER EAGLE® case and close the ICD-40S software.

1 2 ... 8 9 10 11 12 13 14 15 16

Sem comentários

Eagle 105 Manual de Instruções Página 13