Weather Eagle® 105-110 Instruction Manual Page-7-
Weather Eagle(R) 105 SetUp Menu
Firmware Version: 1.012 04/16/06
C- Current settings.
1 - Channel on powerup (Scan/or Last Selected).
2 - RSSI/Tone diagnostics on RS232 port (Enable/Disable).
3 - Remote Unmute Logic In(Enable/Disable).
4 - Rescan for strongest signal every 60 seconds (Enable/Disable).
5 - Relay closure on 1050 alert (Enable/Disable).
6 - Live audio on 1050 alert (Enable/Disable)
7 - Beep on 1050 alert(Enable/Disable).
8 - Set hrs/min/sec of live audio on 1050 Hz alert or timeout.
9 - Set hrs/min/sec of relay closure on 1050 Hz alert.
A - Close relay on Live and Play.
D - Restore default settings.
E - End menu setup routine.
F - Live_Timeout Reset (Enable/Disable).
G - Beep chanel number. (Enable/Disable).
a. Option C brings up the current settings. You may need to scroll up in
Hyperterminal to see them.
b. Option 1 is normally set for last channel on power up. This way the channel you
have chosen for the SAME codes will appear on the next power up session, and
will remain until changed by you. The scan feature is for WE105 users using the
1050 Hz wide area alert tone who are likely to go between different NWR
transmitters. The scan feature measures the received RF signal strength of each
of the 7 NWR channels on each scan routine and then chooses the channel with
the strongest signal strength.
c. Option 2 is the RSSI (received signal strength indication) and 1050 alert tone
diagnostic. This option sends the computer analysis of the RSSI and 1050 Hz
(when inserted with a signal generator into the antenna connection) out the
WE105 comm port to Hyperterminal. This option is normally DISabled.
d. Option 3 is the remote logic in (active high) mute. When this option is enabled
and +5 VDC is input into pin 8 of the WE105 DB15, the WE105 will mute. When
connected to a repeater COS, this feature will make the WE105 secondary
priority over other communication on the repeater. This option is normally
DISabled.
e. Option 4 is to rescan the 7 NWR channels once a minute for the strongest
channel. This option is for mobile operations and is normally DISabled.
f. Option 5 is the WE105 relay closure on 1050 Hz alert. This option is normally
DISabled, as the relay is normally closed on live (see later option) when there is
a SAME match, not when there is only a 1050 Hz tone detected.
g. Option 6 is live audio on 1050 Hz alert. This option provides a good way of
monitoring new alerts as the 1050 Hz alert is issued for most alerts, but the
SAME will only match for event and location. NOTE: if you are connecting the
AE400 into a public address system, you may want to DISable this feature as
© 2006 Thunder Eagle, Inc. All rights reserved worldwide.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais